perlcc
Charles S. Wilson
cwilson@ece.gatech.edu
Sun Oct 31 19:54:00 GMT 1999
As far as I am aware, perlcc was not truly enabled until some patches
were added post-version_61. (I'm surprised you're getting any response
at all with verion 5.005_03.) These patches are included in the
perl5.005_61 port on the cygutils website. So try that version;
hopefully it will work (without GDPro). What is GDPro anyway? Is it a
perl module or some separate program?
--Chuck
P.S. If it turns out that you DO need GDPro - of course there's a way
around the version mismatch problem. Rebuild GDPro from source using
your new 5.005_61 perl. :-)
Gabriele Dionisi wrote:
>
> I downloaded the binary version of perl
> (perl5.005_03-cygwinb20-dynamic-v1.4.tar.bz2) but when I run perlcc it
> complains because it can't find some GDPro perl library. I installed the
> last version of GDPro but now perlcc complains that the version of the
> GDPro library is too old.
> Does anyone know how to overcome this problem?
>
> Thank you very much,
> Gabriele
>
> --
> Want to unsubscribe from this list?
> Send a message to cygwin-unsubscribe@sourceware.cygnus.com
--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com
More information about the Cygwin
mailing list